Preparing the Camcorder34• As long as [~ Camera Setup] > [Periph. Illum. Corr.] is set to [On], the camcorder will automatically applythe appropriate correction data.NOTES• About lens correction data:- The camcorder contains a register of correction data for compatible lenses that were available at the timethe camcorder went on sale. Correction data for future lenses will be made available as part of the regularupdates released for the camcorder’s firmware. For more details, visit your local Canon Web site.- Depending on the recording conditions, noise may appear in the periphery of the image as a result of thecorrection.- The level of correction will be lower for lenses that cannot provide distance information.- The level of correction will be lower the higher the ISO speed/gain setting used.- No correction will be applied when correction data is not available for the lens attached.- When using EF-S lenses, peripheral illumination fall-off may be more pronounced.- When using non-Canon lenses, peripheral illumination will not be corrected.$ Attaching a PL Lens1 Set the Q switch to OFF.2 Hold a bayonet ring handle and turn the bayonet ringcounter-clockwise to remove the body cap and removeany dust caps from the lens.3 Attach the lens to the camcorder aligning a groove on thelens with the PL lens index pin on the mount.4 Turn the bayonet ring clockwise to fix the lens in place.Attaching and Removing the Monitor UnitYou can attach the monitor unit to the accessory shoe onthe camcorder or that on the handle unit. Further ahead youwill find details about using the LCD panel and adjusting theLCD screen (A 36).Attaching the Monitor Unit1 Set the Q switch to OFF.2 Insert the attachment base of the monitor unit to thecamcorder’s or the handle unit’s accessory shoe.• Use the attachment base at the bottom of the monitorunit to attach it directly to the camcorder. Use theattachment base at the back of monitor unit to attach itto the accessory shoe on the front of the handle unit.3 Tighten the monitor unit’s lock screw.4 Connect the monitor unit’s cables to the camcorder.• Connect cable number 1 (with the white line) to thecamcorder’s EXT 1 terminal and cable number 2 to theEXT 2 terminal.COPY
