5. Use the button to select Yes, then press the OK button.The Caller history list is printed.TX ReportThis machine can print a TX (transmission) report after sending a document, confirming whetherthe transmission has been completed successfully. At the time of purchase, TX reports are set tobe printed only when a transmission error occurred. You can set the machine to print a report eachtime it sends a document, or disable printing of the report.NoteFor details on the TX report settings, see TX Report.For the errors that occur when you send a fax, see Errors when you send a fax .Errors when you send a faxIf an error occurs when you send a fax, the error number is printed in the TX report (there are someerrors for which the cause is also printed).The causes corresponding to the error numbers are as follows.No. Cause Action#001 Document is jammed inthe ADF.The document is jammed in the ADF.Remove the document page jammed in theADF. When the error is cleared, redo theoperation. See Document Jams in the ADF .#003 Document is too long. You attempted to send a document longer than15.75 inches / 400 mm.You cannot send a document longer than15.75 inches / 400 mm from the ADF.#003 is also printed if it takes time to send apage. Divide the document or set the imagequality (Fax resolution) to a lower setting, thenresend it.#005 No answer. The recipient's fax machine does not respond.Contact the recipient and have the recipientcheck that the telephone line is connectedcorrectly.#012 Try again. There is no paper in the recipient's faxmachine.Contact the recipient and have the recipientload paper.#017 No tone is detected. The machine could not detect the dial tone.Dial tone detect in Transmission settings is setto ON. Set it to OFF, then send the fax.#018 Line was busy. The fax/telephone number you dialed is busy.Try dialing again after waiting for a moment.#022 Try again. The fax/telephone number registered to thespeed dial is incorrect.Check the recipient's fax/telephone number,correct the fax/telephone number registered tothe speed dial code, then send the documentagain.#059 Transmission has beencanceled due to a faxinformation mismatch.Transmission has been canceled because themachine could not detect the recipient's faxmachine information or the information did notmatch the dialed number. This error number isdisplayed when Check RX fax information isset to ON. For details, see Sending Faxes afterPage 804 of 1127 pagesSummary of Reports and Lists
