3-13Special Features3Proceed to copy in the usual manner.(See “Making Copies,” on p. 2-4.)MEMO: ● To cancel the settings, press the [SPECIALFEATURES], [MARGIN], and [C] keys in that order.● You can also cancel the mode by pressing the Resetkey. (The copier returns to the Standard mode.)Specify the margin width [0" - 3 / 4 " (0 ~ 20 mm)],then press the [OK] key.Use the [+] and [–] keys to set the width of themargin.• Press the [+] key to increase the width of themargin.• Press the [–] key to decrease the width of themargin.• Press the [mm] key to enter in millimeters.MEMO: ● The default setting for the margin width is 3 /8" (10 mm).● Using the “Inch Entry” in the Additional Functionsmode, you can set the copier so that entry can onlybe done in millimeters.In this case the [INCH] key is not displayed.After you have finished making the settings,press the [DONE] key.
