4-9Additional FunctionsSelect the DRAWER ELIGIBILITY FOR APS/ADS.For each paper drawer, select the [ON] or [OFF]key, then press the [OK] key.NOTICE: ● In order to set Drawer Eligibility for APS/ADS, firstyou must place the same sized paper in morethan one paper drawer/Side Paper Deck.MEMO: ● The default setting for all paper drawers is “DrawerEligibility for APS/ADS: ON.”● If different types of copy stock which are the samesize are loaded in different paper drawers or theSide Paper Deck, and you do not want to mix themtogether, then you might want to turn this functionOFF.● If you want the copier to choose the stack bypasswhen a paper drawer runs out of copy paper, thenyou must specify the size of the paper loaded in thestack bypass. (See “Additional functions / StackBypass Size Setting,” on this page.)Select the [ON] or [OFF] key and press the[DONE] key.MEMO: ● The default setting for the Stack Bypass SizeSetting is OFF.■ Stack Bypass Size SettingWhen making two-sided and overlay copies, etc. on copystock placed in the stack bypass, you must enter the sizeof the copy stock.OFF: The size entry display appears right after theStart key is pressed.ON: The size entry display will appear when copy stockis placed in the stack bypass.