2-35Basic CopyingIf the interrupted copy job was being run using the RDF, and you use the SADF tray for interruptcopying, then you do not need to lift or lower the RDF to remove an original from the platen glass.When Placing an Original in the SADF Tray of the RDFPress the Interruptkey.The Interruptkey begins flashing.1After the current copy job has stopped, the Interruptkey lights continuously. The message to theright appears in the touch panel display,indicating that you can begin copying.MEMO: ● When the copier is programmed to Auto Start, youcannot use the Interrupt mode.● If an ID number was being used to run the currentcopy job, then, after the Interruptkey is pressed the IDnumber entry screen is displayed and an ID numbermust be entered in order to make interrupt copies.(See “Entering an Access-control ID Number,” onp. 2-38.)Open the SADF tray of the RDF.MEMO: ● If the interrupted copy job was being run using theplaten glass, temporarily remove the original fromthe platen glass.2Program the necessary copy settings.MEMO: ● You can enter up to 999 copies.3ClearGuideAdditional FunctionsInterruptResetClearEnergy SaverStopGuideAdditional FunctionsInterruptStartDisplay Contrast
