Troubleshooting70Problem Possible Cause Try ThisCannot Print toEnd of Job Incorrect page sizeis selected Ensure that the page size setting matches the size of the paper loaded in theprinter:z Check the PPaper Size setting from within your application to ensure that itmatches the size of the paper loaded.z Check PPaper Size on the PPage Setup tab in the PPrinter Properties dialog box ofthe printer driver (Windows) or the PPage Setup dialog box of the printer driver(Macintosh) to ensure that it matches the size of the paper loaded.There is not enoughfree space on thehard diskYour operating system may be out of free disk space.Check the available space on your computer’s hard disk.The size of the printdata is too large Check the size of the print data. For Windows XP and Windows 2000, if the size ofthe data is too large, part of it may be lost. When the spool format is EMF, followthe procedure below.1. Open the PPrinter Properties dialog box.2. On the MMain tab, click PPrint Options.3. Select the RReduce spool data size check box, and click OOK.When RReduce spool data size is set, the print quality may bedegraded.Use reducedprinting is notselected whenperformingautomatic duplexprintingIn automatic duplex printing, the printable area at the top of the page is 2 mm/0.08 inches narrower than the usual area, therefore the bottom edge may not beprinted. To prevent this, select UUse reduced printing in the printer driver.Print layout may be altered with the reduced printing function.1. Open the PPrinter Properties dialog box.2. Click PPrint Area Setup in the PPage Setup tab and select UUse reduced printing.1. In the PPrint dialog box, select DDuplex Printing & Margin from the pop-up menu.2. Select AAutomatic Duplex Printing, and select UUse reduced printing in PPrintArea.