Canon TM-200 Online Manual

Also see for imagePROGRAF TM-200: Service guide Quick guide Setup guide

OversizeSpecifies whether margins are within or outside the HP-GL/2 data image drawing range.This setting item is displayed by tapping in the following order.(Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings• Enable (Initial setting)Specifies margins outside the HP-GL/2 data image drawing range.Adding margins outside the image drawing range will not cause part of the image to be cut off.However, you will need to print on paper of a size that is greater than the size of the image drawingrange specified by the HP-GL/2 data plus the top, bottom, left, and right margins.• DisableSpecifies margins inside the HP-GL/2 data image drawing range.Depending on the layout, adding margins inside the image drawing range may cause part of the imageto be cut off.Note• Some CAD applications can cause the origin to be out of position and part of the image to be cutoff. Experiment with the Disable and Enable settings of this function to find the one that worksbest.OVERSIZE SETTING EXAMPLESA. Printed page sizeB. Image drawing rangeWhen you print an image above, using Oversize allows you to select where to apply margins (outside/inside the image) based on the image drawing range.Select Enable to apply margins outside the image, or select Disable to apply those inside.• When Disable is selected:Printing is performed based on the image drawing range. The origin is specified on the upper left ofthe paper.174