Canon TM-200 Online Manual

Also see for imagePROGRAF TM-200: Service guide Quick guide Setup guide

Paper is not cut straightCheck 1 Is the edge of the paper cutting position creased?Straighten out any curling by the edges of the paper.Check 2 Is the edge of the paper cutting position lifting up when cutting?Reload the paper correctly.Check 3 Is the paper a type that can be cut with the cutter blade?Set Cutting mode in the touch screen menu to User cut, then and cut the roll paper with a cutting implementsuch as scissors.Specifying the Cutting Method for RollsCheck 4 Are you using the basket properly?Make sure that you are using the basket properly.Using the BasketCheck 5 Check that the Cut speed setting is correct.Select Paper settings > Advanced on Paper menu in the touch screen menu, and change Cut speed.If the paper edge cannot be cut straight at the cut starting position, it may be improved by selecting slower cutspeed than that selected currently.If the paper edge cannot be cut straight at the cut ending position, it may be improved by selecting faster cutspeed than that selected currently.Select Paper settings > Advanced on Paper menu in the touch screen menu, and change the Cut speedsetting.Menu StructureCheck 6 Did the printing material slip diagonally while being cut?Set the Cutting mode in the touch screen menu to Eject cut, and then hold and cut the material after it hasprinted.Specifying the Cutting Method for RollsCheck 7 Is the cutter blade attached properly?Attach the cutter blade properly.Replacing the Cutter Blade680