Canon TM-200 Online Manual

Also see for imagePROGRAF TM-200: Service guide Quick guide Setup guide

Adjusting Line LengthTo ensure that lines in CAD drawings are printed at exactly the right length, use Adjust feed length toadjust the amount that paper is advanced.There are two options in Adjust feed length : Print alignment pattern and Change adjustment values.Note• We recommend executing the adjustment if you have changed the paper type or paper size.• Always check the Set priority values before adjustment.Selecting Feed Amount Adjustment MethodItems to PrepareWhen Using Rolls • An unused roll at least 254.0 mm (10.00 in) wide• High-precision rulerWhen Using Sheets • One sheet of unused paper of at least A4/Letter size• High-precision rulerFollow the procedure below to adjust.1. Load paper.Loading Rolls on the Roll HolderLoading Rolls in the PrinterLoading Sheets in the PrinterImportant• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot becompleted correctly unless the loaded paper matches the settings.2. On the HOME screen, tap (Setup).Menu Operations3. Tap Maintenance.4. Tap Paper feed adjustment.5. Tap Adjust feed length.6. Tap Print alignment pattern or Change adjustment values.• If you tap Print alignment pattern:The test pattern is printed for you to measure the scale and calculate the discrepancy.The scale bar prints "Millimeter" in 50 mm increments and "Inch" in 1-inch increments.370