159Appendix8Messages Displayed in the Information FieldMessages displayed in the information field of the viewer are classified into the following three types. Information MessagesList of Viewer MessagesIcon Category ExplanationInformation Message Help messages on various buttons, pull-down lists, etc., as well as frame rate and otherinformation from the camera are shown.Warning Message A message will be displayed notifying the user when camera control privileges cannotbe obtained, the audio session stops, etc.Error Message Displayed when a system error occurs in the viewer.Message ExplanationConnection closed by the camera. The camera was disconnected.Audio connection has been closed. The video session has continued after the audio session was disconnected(applicable to both transmission and reception).Camera control gained. Displayed when camera control is obtained. You can operate the camera.Camera control lost. Displayed when camera control is released. You cannot operate the camerauntil you get camera control privileges again.Use the menu displayed by right-clicking to exit the fullscreen mode.When switched to full screen modeRecording to SD card aborted. When recording to SD card was completed successfullyThe connection was terminated because the image hasbeen flipped.When the image was flipped during camera connection (camera connectionis terminated when an image is flipped)The connection was terminated because the passwordhas been changed.When the password of the account used to connect to the camera waschanged during camera connection and then any WV-HTTP command wasissuedMessage Explanation{n}fps Pan : {p} Tilt : {t} Zoom : {z} IS: {Image Stabilizervalue}Communicating with the camera normallyMessage Explanation{n}fps Pan : {p} Tilt : {t} Zoom : {z} Communicating with the camera normally (when Digital PTZ is enabled){n}fps Communicating with the camera normally (when Digital PTZ is disabled)
