[Network] Setting Administrator Password, LAN, IP Address, DNS, etc5-75 Setting PageSNMP1 [SNMP]Set SNMP use to [Disable] or [Enable]. Camerainformation can be referenced by the SNMP Manager if[Enable] is specified.2 [Community Name]Set a community name for SNMP. It is recommendedthat you change the community name to ensure systemsecurity.3 [Administrator Contact Information]Set contact information (e-mail address, etc.) for theAdministrator of the camera. Setting information can bereferenced by the SNMP manager.4 [Administration Function Name]Set the camera name used for administration. Settinginformation can be referenced by the SNMP manager.If left blank, “VB-M700” will be used by default for VB-M700F and “VB-M600” will be used by default for VB-M600D/VB-M600VE.5 [Installation Location]Set information regarding the installation location of thiscamera. Setting information can be referenced by theSNMP manager.Note• The information set in the camera is read-only from the SNMPmanager.• Use the SNMP Manager that supports SNMP MIB2 (supportingRFC1213).• Supports SNMP protocol versions v1 and v2c (v3unsupported).
