Service Call Message6-14Troubleshooting6Requesting Repairs from the Control PanelIf you notice an abnormality with the machine, you can send a repair request fromthe touch panel display.WARNINGDo not connect or disconnect the power cord with wet hands, as this may resultin electrical shock.CAUTIONAlways grasp the power plug portion when disconnecting the power cord.Pulling on the cord may expose or snap the core wire or otherwise damage thepower cord. If the power cord is damaged, this could cause current to leak,resulting in a fire or electrical shock.IMPORTANTTo make repair requests from the touch panel display, the machine must be configuredbeforehand. For more information, contact your local authorized Canon dealer.The machine starts up in the LimitedFunctions Mode.NOTEAfter the problem with the finisher issolved, disable the Limited FunctionsMode from the Additional Functionsmenu. (See “Configuring theMachine’s Basic Settings” in thee-Manual.)1 Press (Counter Check) on thecontrol panel.