Cardinal 225 Installation And Technical Manual

Also see for 225: Installation and technical manual Installation, Set-Up and Operation Manual

Contents

Cardinal 225 Installation And Technical Manual Manual pdf 94 page image

PRESET WEIGHT COMPARATORS OPERATIONetup ofXXX 10. P=XXXXXX 16. P=XXXXXXThe Model 225 indicator has sixteen (16) outputs, which can be configured during the sPWC”. If the PWC feature wasthe weight indicator to perform as Preset Weight Comparators “sele ect d during setup, the indicator will compare each enabled preset weight value with thedisplayed weight and then output a signal for each preset based on the comparison results.Enter Preset Values14. With the indicator in normal operations mode, press the PRESET key.1. P=XXXXXX 7. P=XXXXXX 13. P=XXXX2. P=XXXXXX 8. P=XXXXXX 14. P=XXXXXX3. P=XXXXXX 9. P=XXXXXX 15. P=XXXXXX4. P=XXXXX5. P=XXXXXX 11. P=XXXXXX 17. SET TRIM6. P=XXXXXX 12. P=XXXXXXENTER to EXIT, or PWC# TO CHANGE: 0PRESET(PRESE1. P=XXXXXX T 1 WEIGHT VALUE)through16. P=XXXXXX (PRESET 16 WEIGHT VALUE)15. The display will change to show the 16 presets. Note that XXXXXX is the current valuedvalues.ct the PWC#tR.ENTER key to exit and return tofor each preset.16. If the values displayed for each preset are acceptable, press the ENTER key to exit anreturn to normal operation or press the 1 and 7 keys and then the ENTER key to enterthe preset trim weight17. Otherwise, to change a preset weight value, use the numeric keys to seleto change and then press the ENTER key. The display will change to show the currenvalue of the preset selected.18. Using the numeric keys, enter the new value for the preset and then press the ENTEkey to save the new setting.19. Continue with this procedure until a value for each preset to be used has been entered20. After the last preset value has been entered, press thenormal operation.NOTE! Enter a zero (0) then press the ENTER key if the preset weight comparator isnot to be used.8200-M538-O1 y 225 Installation Page 90