Cardinal 225 Installation And Technical Manual

Also see for 225: Installation and technical manual Installation, Set-Up and Operation Manual

Contents

Cardinal 225 Installation And Technical Manual Manual pdf 98 page image

8200-M698-O1 Rev B  225 Installation and Technical90CALIBRATION AND SETUP, CONT.KEY LOCKOUT6. KEY LOCKOUT (KEY LOCKOUT)The key lockout parameter determines which keys are locked during normal operation.Pressing a locked key during normal operation will result in a warning beep, a 1/2 seconddisplay of -LOCKED- and the key will be ignored.With the SETUP MENU #3 displayed press the 6 key and then the ENTER key. The displaywill change to show the Key LOCKOUT Menu.Key LOCKOUT Menu1. ZERO=NO 6. UNITS=NO 11. GREEN=NO2. TARE=NO 7. ACCUM=NO3. NET=NO 8. KEYPAD=NO4 PRINT=NO 9. ID=NO4. TIME=NO 10. COUNT=NOEnter Selection: 01. The display will change to show the 11 keys that can be locked and the current statusfor each key.2. If the status of each key displayed is acceptable, press the ENTER key to exit andreturn to SETUP MENU #3.3. Otherwise, to change the lockout status of a key, use the numeric keys to select the keyto change and then press the ENTER key.4. The display will change to show Lockout XXXXXX? XXX and turn on the YESand NO soft keys. Note that XXXXXX is the key and XXX is the current lockout status.Key LOCKOUT Menu1. ZERO=NO 6. UNITS=NO 11. GREEN=NO2. TARE=NO 7. ACCUM=NO3. NET=NO 8. KEYPAD=NO4 PRINT=NO 9. ID=NO4. TIME=NO 10. COUNT=NOLockout XXXXXX? XXXYES NO5. Press the YES or NO (on the soft keys) and then the ENTER key to save the newsetting and return to the Key LOCKOUT Menu.6. Continue with this procedure until the status of each key has been entered.7. After the last key lockout status has been entered, press the ENTER key to exit andreturn to SETUP MENU #3.