ε-23Using the MULTIMETER Mode5. Using the MULTIMETER ModeYou can use the Channel Setup screen (page ε-9) to configure a channel so that DataLogger MULTIMETER mode sampling is triggered by a calculator operation.• To use the MULTIMETER mode1. Connect the calculator and Data Logger, and connect the sensors you want to theapplicable Data Logger channels.2. From the Advanced Setup menu (page ε-8), use the Channel Setup screen (page ε-9) toconfigure sensor setups for each channel you will be using.3. After configuring the sensor setups, press w to return to the Advanced Setup menu(page ε-8), and then press 2(MULTI).• This starts sampling in the Data LoggerMULTIMETER mode and displays a list of samplevalues for each channel.• Displayed sample data is refreshed at 0.5-secondintervals.• Do not connect sensors to any other channels exceptfor those you specified in step 2.• Data sampled in the MULTIMETER mode is not saved in memory.4. To end MULTIMETER mode sampling, press the w key.
