ε-48Graph Analysis Tool Graph Screen Operationsk Outputting a Specific Range of a Graph from the Speaker(EA-200 only)Use the following procedure to output a specific range of a sound data waveform graph fromthe speaker.• To output a graph from the speaker1. On the graph screen, press K, and then 6(SPEAKER).• This displays the trace pointer for selecting the rangeon the graph.2. Move the trace pointer to the start point of the range you want to output from the speaker,and then press w.3. Move the trace pointer to the end point of the range you want to output from the speaker,and then press w.• After you specify the start point and end point, an output frequency dialog box shownbelow appears on the display.→4. Input a percent value for the output frequency value you want.• The output frequency specification is a percent value. To output the original sound as-is,specify 100%. To raise the original sound by one octave, input a value of 200%. Tolower the original sound by one octave, input a value of 50%.5. After inputting an output frequency value, press w.• This outputs the waveform between the start point and end point from the EA-200speaker.• If the sound you configured cannot be output for some reason, the message “RangeError” will appear. If this happens, press J to scroll back through the previous settingscreens and change the setup as required.6. To terminate sound output, press the EA-200 [START/STOP] key.7. Press w.• This displays a screen like the one shown nearby.
