9-5S Using the JUMP Command to Move the Cell CursorTo move the cell cursor to here: Do this:A particular cell 1. Press (EDIT)(JUMP)(GO).2. On the dialog box that appears, enter the nameof the cell (A1 to Z999) to which you want tojump.3. Press U.Line 1 of the current column Press (EDIT)(JUMP)(TOPl).Column A of the current row Press (EDIT)(JUMP)(TOPk).Last line of the current column Press (EDIT)(JUMP)(BOTn).Column Z of the current row Press (EDIT)(JUMP)(BOTm).S To select a range of cells1. Move the cell cursor to the start point of the range of cells you want to select.• You could select and entire row or column of cells as the start point, if you want. For detailsabout selecting cells, see “To select cells” on page 9-4.2. Press G(CLIP).• This will change the cell cursor to a thick-line boundary instead of the normal highlighting.3. Use the cursor keys to move the cell cursor to the endpoint of the range of cells you want to select.• The edit box will show the range of the selected cells.• To cancel cell selection, press ). If you do, the cellcursor will be located at the end point of the range youselected.I Data (Constants, Text, Formula) Input BasicsFirst let’s have a look at a few basic procedures that apply regardless of the type of data youare inputting.S To overwrite data currently in a cell with new data1. Move the cell cursor to the cell where you want to input data.• If the cell you select already contains data, the following step will overwrite the existingdata with new input.2. Use the calculator’s keys to input data.• As you perform key operations to input values or text(such as @, ?J(B), etc.), the applicable figureswill appear aligned left inside the edit box.• To cancel an input operation part way through at anypoint before advancing to step 3 below, press ). Thiswill return the cell contents to what they were in step 1of this procedure.3. To finalize and apply your input, press U.
