ES601-US OPERATING MANUALAutomated Testing/Chapter 6 # Page 100Figure 66 - Safety AutoSequence menuTwenty-four Safety AutoSequences are listed across four menu screens or "pages". Default AutoSequencesdelivered with the analyzer provide a number of examples for several safety standards (IEC; AAMI; VDE).Scroll through these screens using the PREV PAGE or NEXT PAGE buttons to locate the desired SafetyAutoSequence. Select the Safety AutoSequence by pressing the button to the left of the sequence's title.BACK returns to the AUTOMATED TESTS menu.As described in Section 6.1 AutoSequence Overview, after selecting a safety test you will be prompted to inputinformation about the equipment under test. At this stage, it is not mandatory to enter any equipmentinformation and the safety test can be launched immediately, simply by pressing the RUN TEST button.However, to save a Record of the test it will be necessary to enter at least a Control Number, which can bedone after the safety test is complete.Per Section 6.1, if pre-test inspection has been enabled in the System Settings, you will be prompted toinspect the equipment and enter comments. Following the inspection prompts, you are presented withvarious menus that will allow you to modify the settings of the Safety AutoSequence before the test isstarted. These displays will be similar to menus described in detail in Sections 3.3 and 5.10 of this manual.Any changes made to AutoSequence settings will remain in effect for the duration of the test, then willrevert to the AutoSequence setup stored in memory when the test is completed. If modifications arenecessary for more than one test, you should consider programming and saving such changes by means ofthe Edit Safety menu, described in Section 3.6.For a safety test, the first menu presented will be instructions for connecting the DUT to ES601-US. On