FC 300 Design GuideHow to Program" Parameter SelectionIn Main Menu mode, the parameters are dividedinto groups. You select a parameter groupusing the navigation keys.The following parameter groups are accessible:Group no. Parameter group:0 Operation/Display1 Load/Motor2 Brakes3 References/Ramps4 Limits/Warnings5 Digital In/Out6 Analog In/Out7 Controls8 Comm. and Options9 Profibus10 CAN ser. com. bus11 Reserved Com. 112 Reserved Com. 213 Smart Logic14 Special Functions15 Drive Information16 Data Readouts17 Motor Feedb. OptionAfter selecting a parameter group, choose aparameter using the navigation keys.The middle section on the display shows theparameter number and name as well as theselected parameter value.130BP067.10" Changing DataThe procedure for changing data is the same whether you select a parameter in the Quick menuor the Main menu mode. Press [OK] to change the selected parameter.The procedure for changing data depends on whether the selected parameter representsa numerical data value or a text value." Changing a Text ValueIf the selected parameter is a text value, change thetext value by means of the up/down navigation keys.The up key increases the value, and the downkey decreases the value. Place the cursor on thevalue you want to save and press [OK].130BP068.10143MG.33.B6.22 - VLT is a registered Danfoss trademark
