Danfoss VLT AQUA Drive FC 202 Operating Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

VLT® AQUA Drive FC 202 N200 N250High/normal overload HO NO HO NO(High overload=150% current during 60 s.Normal overload=110% current during 60 s)Typical shaft output at 525 V [kW] 132 160 160 200Typical shaft output at 575 V [hp] 200 250 250 300Typical shaft output at 690 V [kW] 160 200 200 250Enclosure size D2h/D4h/D7h/D8hOutput current (3-phase)Continuous (at 525 V) [A] 201 253 253 303Intermittent (60 s overload) (at 525 V) [A] 301 278 380 333Continuous (at 575/690 V) [A] 192 242 242 290Intermittent (60 s overload) (at 575/690 V) [A] 288 266 363 319Continuous kVA (at 525 V) [kVA] 183 230 230 276Continuous kVA (at 575 V) [kVA] 191 241 241 289Continuous kVA (at 690 V) [kVA] 229 289 289 347Maximum input currentContinuous (at 525 V) [A] 193 244 244 292Continuous (at 575/690 V) 185 233 233 279Maximum number and size of cables per phase- Mains, motor, brake, and load share [mm2 (AWG)] 2x185 (2x400) 2x185 (2x400)Maximum external mains fuses [A]1) 550 550Estimated power loss at 575 V [W]2), 3) 2361 3074 3012 3723Estimated power loss at 690 V [W]2), 3) 2446 3175 3123 3851Efficiency3) 0.98 0.98Output frequency [Hz] 0–590 0–590Heat sink overtemperature trip [°C (°F)] 110 (230) 110 (230)Control card overtemperature trip [°C (°F)] 80 (176) 80 (176)Table 10.7 Electrical Data for Enclosures D2h/D4h/D7h/D8h, Mains Supply 3x525–690 V AC1) For fuse ratings, see chapter 10.7 Fuses and Circuit Breakers.2) Typical power loss is at normal conditions and expected to be within±15% (tolerance relates to variety in voltage and cable conditions). Thesevalues are based on a typical motor efficiency (IE/IE3 border line). Lower efficiency motors add to the power loss in the drive. Applies todimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses can increase. LCP and typical controlcard power consumptions are included. For power loss data according to EN 50598-2, refer to www.danfoss.com/vltenergyefficiency. Options andcustomer load can add up to 30 W to the losses, though usually a fully loaded control card and options for slots A and B each add only 4 W.3) Measured using 5 m (16.4 ft) shielded motor cables at rated load and rated frequency. Efficiency measured at nominal current. For energyefficiency class, see chapter 10.4 Ambient Conditions. For part load losses, see www.danfoss.com/vltenergyefficiency.Specifications VLT® AQUA Drive FC 202104 Danfoss A/S © 09/2018 All rights reserved. MG21A5021010