UMN:CLI User ManualV58081226.2 Configuration ManagementYou can verify if the system configurations are correct and save them in the system.6.2.1 Displaying System ConfigurationTo display the current running configuration of the system, use the following command.Command Mode Descriptionshow running-configAllShows a configuration of the system.show running-config syslog Shows syslog information.show running-config {admin-flow | admin-policy |arp | bridge | cpu-pkt-filter | dhcp | dhcp6 | dns |flow | full | hostname | interface [INTERFACE] |interface tunel <0-1023>| login | nd | policer |policy | pppoe | qos | rmon-alarm | rmon-event |rmon-history | router {bgp | rip | ospf | vrrp} |router ipv6 ospf | router ipv6 vrrp | snmp | syslog| time-out | time-zone}Shows a configuration of the systemwith the specific option.show running-config {dba-profile [NAME] |extended-vlan-tagging-operation [NAME] | gpon |gpon-node | gpon-olt [PORT] | multicast-access-list [NAME] | multicast-profile [NAME] | onu-profile [NAME] | pm-profile [NAME] | pw-maintenance-profile [NAME] | rate-limit-profile[NAME] | tdm-pw-profile [NAME] | traffic-profile[NAME] | voip-profile [NAME] }Shows the configurations of thesystem with the GPON option.The following is an example to display the configuration of the syslog.SWITCH# show running-config syslog!syslog output info local volatilesyslog output info consolesyslog output debug local non-volatile!SWITCH#6.2.2 Writing System ConfigurationIf you change the configuration of the system, you need to save the changes in thesystem flash memory. To write a current running configuration, use the followingcommand.Command Mode Descriptionwrite memory All Writes a current running configuration in the systemflash memory.
