UMN:CLI User ManualV5808130The followings are the configurable options to trace the routes.Items DescriptionProtocol [ip] Supports ping test. Default is IP.Target IP address Sends ICMP echo message by inputting IP address or host name ofdestination in order to check network status with relative.Source address Source IP address which other side should make a response.Numeric display [n] Hop is displayed the number instead of indications or statistics.Timeout in seconds [2] It is considered as successful ping test if reply returns within theconfigured time interval. Default is 2 seconds.Probe count [3] Set the frequency of probing UDP packets.Maximum time to live [30]The TTL field is reduced by one on every hop. Set the time to tracehop transmission (The number of maximum hops). Default is 30seconds.Port Number [33434] Selects general UDP port to be used for performing to trace theroutes. The default is 33434.Tab. 6.3 Options for Tracing Packet RouteThe following is an example of tracing packet route sent to 10.55.193.104.SWITCH# traceroute 10.55.193.104traceroute to 10.55.193.104 (10.55.193.104), 30 hops max, 40 byte packets1 10.45.239.254 (10.45.239.254) 2.459 ms 1.956 ms 1.781 ms2 10.45.191.254 (10.45.191.254) 1.114 ms 2.112 ms 1.786 ms3 10.45.1.254 (10.45.1.254) 2.723 ms 2.604 ms 1.767 ms4 10.55.1.1 (10.55.1.1) 2.532 ms 2.522 ms 1.793 ms5 10.55.1.1 (10.55.1.1) 1.623 ms 0.879 ms 1.755 ms6 10.55.193.104 (10.55.193.104) 9.375 ms 3.817 ms 2.514 msSWITCH#6.3.4 Displaying User Connecting to SystemTo display current users connecting to the system from a remote place or via consoleinterface, use the following command.Command Mode Descriptionwhere Enable Shows current users connecting to the system from aremote place or via console interface.The following is an example of displaying current users connecting to the system.SWITCH# whereadmin at ttyp0 from 10.20.1.32:2196 for 30 minutes 35.56 secondsadmin at ttyS0 from console for 28 minutes 10.90 secondsSWITCH#
