Changing port settings after installing a newnetwork Internal Solutions PortWhen a new network Internal Solutions Port (ISP) is installed in the printer, the printer configurations on computersthat access the printer must be updated because the printer will be assigned a new IP address. All computers thataccess the printer must be updated with this new IP address in order to print to it over the network.Notes:• If the printer has a static IP address that will stay the same, then you do not need to make any changes to thecomputer configurations.• If the computers are configured to print to the printer by a network name that will stay the same, instead of byIP address, then you do not need to make any changes to the computer configurations.• If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure thewired network is disconnected when you configure the printer to operate wirelessly. If the wired connectionremains connected, then the wireless configuration will complete, but the wireless ISP will not be active. Thiscan be fixed by disconnecting the wired connection, turning the printer off, and then turning the printer backon again.For Windows users1 Print a network setup page and make a note of the new IP address.2 Do one of the following:In Windows Vistaa Click .b Click Control Panel.c Under Hardware and Sound, click Printer.In Windows XPa Click Start.b Click Printers and Faxes.In Windows 2000a Click Start.b Click Settings ª Printers.3 Locate the printer that has changed.Note: If there is more than one copy of the printer, then update all of them with the new IP address.4 Right-click the printer.5 Click Properties.6 Click the Ports tab.7 Locate the port in the list, and then select it.8 Click Configure Port.Additional printer setup55
