1262 Configuring IPv6 RoutingIPv6 Show CommandsUse the following commands in Privileged EXEC mode to view IPv6configuration status and related data.Command Purposeshow sdm prefer Show the currently active SDM template.show sdm prefer dual-ipv4-and-ipv6 defaultShow parameters for the SDM template.show ipv6 dhcp interfacevlanvlan-idView information about the DHCPv6 lease acquired bythe specified interface.show ipv6 interface {vlan| tunnel | loopback}interface-idView the IP interface configuration information for thespecified IPv6 routing interface.show ipv6 brief View the global IPv6 settings for the switch.show ipv6 route [ipv6-address |ipv6-prefix/prefix-length |protocol |interface-typeinterface-number] [best]View the routing table.•ipv6-address—Specifies an IPv6 address for which thebest-matching route would be displayed.•protocol—Specifies the protocol that installed theroutes. Is one of the following keywords: connected,ospf, static.•ipv6-prefix/ prefix-length—Specifies an IPv6 networkfor which the matching route would be displayed.•interface-type interface-number—Valid IPv6 interface.Specifies that the routes with next-hops on the selectedinterface be displayed.• best—Specifies that only the best routes are displayed.If the connected keyword is selected for protocol, thebest option is not available because there are no best ornon-best connected routes.show ipv6 route summary View summary information about the IPv6 routing table.show ipv6 routepreferencesView detailed information about the IPv6 routepreferences.
