568 Configuring Port and System SecurityConfiguring Captive Portal (CLI)This section provides information about the commands you use to create andconfigure Captive Portal settings. For more information about thecommands, see theDell Networking N2000, N3000, and N4000 SeriesSwitches CLI Reference Guide at support.dell.com/manuals.Configuring Global Captive Portal SettingsBeginning in Privileged EXEC mode, use the following commands toconfigure global Captive Portal settings.Command Purposeconfigure Enter global configuration mode.captive-portal Enter Captive Portal mode.http portport-num (Optional) Configure an additional HTTP port forCaptive Portal to monitor. Use this command on networksthat use an HTTP proxy server.port-num — The port number to monitor (Range:1–65535, excluding ports 80, 443, and the configuredswitch management port).https portport-num (Optional) Configure an additional HTTPS port forCaptive Portal to monitor. Use this command on networksthat use an HTTPS proxy server.port-num — The port number to monitor Range:1–65535, excluding ports 80, 443, and the configuredswitch management port).authentication timeouttimeout(Optional) Configure the number of seconds the user hasto enter valid credentials into the verification page. If theuser exceeds the configured timeout, the verification pageneeds to be served again in order for the client to gainaccess to the network.timeout — The authentication timeout (Range: 60–600seconds).enable Globally enable the Captive Portal feature.
