Configuring VLANs 705Configure the VLANs and Ports on Switch 2Use the following steps to configure the VLANs and ports on Switch 2. Manyof the procedures in this section are the same as procedures used to configureSwitch 1. For more information about specific procedures, see the details andfigures in the previous section.To configure Switch 2:1. Create the Engineering, Marketing, Sales, and Payroll VLANs.Although the Payroll hosts do not connect to this switch, traffic from thePayroll department must use Switch 2 to reach the rest of the network andInternet through the uplink port. For that reason, Switch 2 must be awareof VLAN 400 so that traffic is not rejected by the trunk port.2. Configure LAG 1 as a general port so that it can be a member of multipleVLANs.a. From the Switching → VLAN → LAG Settings page, make sure Po1is selected.b. From the Port VLAN Mode field, select General.c. Click Apply.3. Configure port 1 as a trunk port.4. Configure LAG2 as a trunk port.5. Assign ports 1–10 to VLAN 200 as untagged (U) members.6. Assign ports 11–30 to VLAN 100 as untagged (U) members.7. Assign LAG1 to VLAN 100 and 200 as a tagged (T) member.8. Assign port 1 and LAG2 to VLAN 100, VLAN 200, VLAN 300, and VLAN400 as a tagged (T) member.9. Configure the MAC-based VLAN information.10. If desired, copy the running configuration to the startup configuration.
