1300 Configuring Differentiated ServicesConfiguring DiffServ (CLI)This section provides information about the commands you use to configureDiffServ settings on the switch. For more information about the commands,see theDell Networking N2000, N3000, and N4000 Series Switches CLIReference Guide at support.dell.com/manuals.DiffServ Configuration (Global)Beginning in Privileged Exec mode, use the following commands in toconfigure the global DiffServ mode and view related settings.DiffServ Class Configuration for IPv4Beginning in Privileged Exec mode, use the following commands to configureDiffServ classes for IPv4 and view related information.CLI Command Descriptionconfigure Enter global configuration mode.diffserv Set the DiffServ operational mode to active.exit Exit to Privileged EXEC mode.show diffserv Display the DiffServ general information, whichincludes the current administrative mode setting aswell as the current and maximum number ofDiffServ components.CLI Command Descriptionconfigure Enter global configuration mode.class-map match-allclass-map-nameDefine a new DiffServ class and enter Class-MapConfiguration mode for the specified class.NOTE: To enter Class-Map Configuration mode for aclass that has already been created, use the class-mapclass-map-name command.match any Configure a match condition for all the packets.match class-map Add to the specified class definition the set ofmatch conditions defined for another class.
