Configuring System Information 157Configuring DNS Servers Using the CLI CommandsThe following table summarizes the CLI commands for configuring device system information.The following is an example of the CLI commands:Defining Default DomainsThe Default Domain Name page provides information for defining default DNS domain names.To open the Default Domain Name page, click System → IP Addressing → Default Domain Name.Figure 6-46. Default Domain NameTable 6-27. DNS Server CLI CommandsCLI Command Descriptionip name-server server-address Sets the available name servers. Up to eight name servers can be set.no ip name-server server-address Removes a name server.ip domain-name name Defines a default domain name that the software uses to completeunqualified host names.clear host {name | *} Deletes entries from the host name-to-address cache.show hosts [name] Displays the default domain name, list of name server hosts, thestatic and the cached list of host names and addresses.ip domain-lookup Enables DNS system for translating host names to IP addresses.console(config)# ip name-server 176.16.1.18
