Configuring Switch Information 389Enabling IGMP Snooping on the device1 Open the Global Parameters page.2 Select Enable in the IGMP Snooping Status field.3 Click Apply Changes.IGMP Snooping is enabled on the device.Enabling Multicast Filtering and IGMP Snooping Using CLI CommandsThe following table summarizes the equivalent CLI commands for enabling Multicast Filtering and IGMPSnooping as displayed on the Global Parameters page.The following is an example of the CLI commands:Adding Bridge Multicast Address MembersThe Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service groupin the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port orLAGs joined the Multicast group. Ports can be added either to existing groups or to new Multicastservice groups. The Bridge Multicast Group page permits new Multicast service groups to be created.The Bridge Multicast Group page also assigns ports to a specific Multicast service address group.To open the Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast Groupin the tree view.Table 7-38. Multicast Filtering and Snooping CLI CommandsCLI Command Descriptionbridge multicast filtering Enables filtering of Multicast addresses.ip igmp snooping Enables Internet Group MembershipProtocol (IGMP) snooping.console(config)# bridge multicast filteringconsole(config)# ip igmp snooping
