Installing the PowerConnect 3524/P and PowerConnect 3548/P 45Stacking PowerConnect 35xx Series Systems SwitchesEach PowerConnect 35xx series systems stack contains a single Master unit, and may have a MasterBackup unit, while the remaining units are considered stacking Members.PowerConnect 35xx series systems switches use the RJ-45 Gigabit Ethernet ports (G3 and G4) forstacking. This enables added stacking capabilities to the devices without adding additional deviceaccessories. To stack the devices together, insert a standard Category 5 cable into port G3 in theuppermost device in the stack, and into port G4 of the device immediately below it in the stack. Repeatthis process until all devices are connected. Connect the bottommost device’s port G3 in the stack toport G4 of the uppermost device in the stack.Figure 3-5. Stacking Cable DiagramNOTE: In stacking mode ports designated as G3 and G4 are not displayed in the EWS. The effect is of not beingpresent on the device. This is because the ports receive a different index for stacking.Stack unit identification is performed on the device front panel using the Stack ID button.
