32 Hardware DescriptionThe RJ-45 LED indications for PowerConnect 3524P and PowerConnect 3548P are described in thefollowing table:Gigabit Port LEDsThe following table describes the Gigabit (stacking port) LEDs:Table 2-2. PowerConnect 3524P and PowerConnect 3548P RJ-45 Copper based 100BaseT LED IndicationsLED Color DescriptionSpeed/Link/Act Green Static The port is currently linked at 100 Mbps.Green Flashing The ports is currently operating at 100 Mbps.OFF The port is currently operating at 10 Mbps or is not linked.FDX Green Static The Powered Device (PD) is detected and is operating at normal load. For moreinformation about Powered Devices, see "Managing Power over Ethernet".Green Flashing The port is operating at transitional mode. The PD is being detected, or is faulty.For more information about Power over Ethernet, see "Managing Power overEthernet".Amber Static An overload or short has occurred on the Powered Device. For more informationabout Power over Ethernet faults, see "Managing Power over Ethernet".AmberFlashingThe powered device power conception exceeds the predefined power allotment.For more information about Power over Ethernet power allotments, see"Managing Power over Ethernet".OFF No powered device is detected.Table 2-3. PowerConnect 3524 and PowerConnect 3548 RJ-45 Copper based 100BaseT LED IndicationsLED Color DescriptionLink/Activity/Speed Green Static The port is running at 1000 Mbs.Green Flashing The port is either transmitting or receiving data at 1000 Mbps.Yellow Static The port is running at 10 or 100Mbs.Yellow Flashing The port is either transmitting or receiving data at 10 or 100 Mbps.OFF The port is currently not operating.FDX Green Static The port is currently operating in Full Duplex mode.OFF The port is currently operating in Half Duplex mode.
