52 Starting and Configuring the Device2 Press Y. The following message is displayed.Write Flash file name (Up to 8 characters, Enter for none.):configFile config (if present) will be erased after system initialization======== Press Enter To Continue ========3 Enter config as the name of the flash file. The configuration is erased and the device reboots.4 Repeat the device initial configuration.Password RecoveryIf a password is lost, the Password Recovery procedure can be called from the Startup menu. The procedureenables entry to the device once without password.To recover a lost password for the local terminal only:1 From the Startup menu, type 3 and press .The password is deleted.NOTE: To ensure device security, reconfigure passwords for applicable management methods.Software Download Through TFTP ServerThis section contains instructions for downloading device software (system and boot images) through aTFTP server. The TFTP server must be configured before beginning to download the software.System Image DownloadThe device boots and runs when decompressing the system image from the flash memory area where a copyof the system image is stored. When a new image is downloaded, it is saved in the other area allocated forthe other system image copy.On the next boot, the device will decompress and run the currently active system image unless chosenotherwise.To download a system image through the TFTP server:1 Ensure that an IP address is configured on one of the device ports and pings can be sent to a TFTP server.2 Make sure that the file to be downloaded is saved on the TFTP server (the ros file).3 Enter show version to verify which software version is currently running on the device. The followingis an example of the information that appears:console# show versionSW version 1.0.0.42 (date 22-Jul-xxxx time 13:42:41)Boot version 1.0.0.18 (date 01-Jun-xxxx time 15:12:20)HW version
