Configuring System Information 183• Hold Multiplier (2-10) — Indicates the number of times that LLDP packets are held before thepackets are discarded. The possible field range is 2 - 10 times. The field default is 4 times.• Reinitializing Delay (1-10) — Indicates the amount of time that passes between disabling LLDP andwhen reinitializing begins. The possible field range is 1 - 10 seconds. The field default is 2 seconds.• Transmit Delay (1-8192) — Indicates the amount of time that passes between successive LLDP frametransmissions due to changes in the LLDP local systems MIB. The possible field value is 1 – 8192seconds. The field default is 2 seconds.Configuring LLDP Using CLI CommandsThe following is an example of the CLI commands:Defining LLDP Port SettingsThe LLDP Port Settings page allows network administrators to define LLDP port settings, including theport number, the LLDP port number, and the type of port information advertised.The Port Settings page contains fields for configuring LLDP. To open the Port Settings page,click System → LLDP-MED → Port Settings in the tree view.Table 6-39. LLDP Properties CLI CommandsCLI Command Descriptionlldp enable (global) Enables enable Link Layer DiscoveryProtocol.lldp hold-multipliernumber Specifies the time that the receivingdevice should hold a Link LayerDiscovery Protocol (LLDP) packetbefore discarding it.lldp reinit-delaySeconds Specifies the minimum time an LLDPport will wait before reinitializing.lldp tx-delaySeconds Specifies the delay between successiveLLDP frame tr.ansmissions.Console(config)# interface ethernet g5Console(config-if)# lldp enable
