Configuring System Information 231Configuring General Device Tuning ParametersThe General Settings page provides information for defining general device parameters. To open theGeneral Settings page, click System → Advanced Settings → General in the tree view.Figure 6-104. General Settings• Attribute — The general setting attribute.• Current — The currently configured value.• After Reset — The future (after reset) value. By entering a value in the After Reset column, memory isallocated to the field table.• Max RAM Log Entries (20-400) — The maximum number of RAM Log entries. When the Logentries are full, the log is cleared and the Log file is restarted.• Jumbo Frames — Enables or disables the Jumbo Frames feature. Jumbo Frames enable thetransportation of identical data in fewer frames. This ensures less overhead, lower processing time, andfewer interrupts.• Switch Mode — Specifies the device working mode. The new mode becomes active only after devicereset. The possible field values are:– ACL & iSCSI — The devices uses Access Control Lists and iSCSI. Dynamic VLAN Assignment isnot used. For more information see "ACL Overview" on page 256 and "Optimizing iSCSI" onpage 232.– DVA & iSCSI — The device uses Dynamic VLAN Assignment and iSCSI. Accesss Control Listsare not used. For more information see "Configuring Advanced Port Based Authentication" onpage 248 and "Optimizing iSCSI" on page 232.
