reset-chassis-lcd-menu;}}}protocols {igmp-snooping {vlan all;}lldp {interface all;}rstp;}ethernet-switching-options {storm-control {interface all;}}RelatedDocumentationConnecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144•• Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146• For information about J-EX Series switch configuration files and interfaces andinstructions for reverting to the factory default configuration, see the Dell PowerConnectJ-Series Ethernet Switch Complete Software Guide for Junos OS athttp://www.support.dell.com/manuals.• J-EX8216 Switch Hardware Overview on page 3Connecting and Configuring a J-EX Series Switch (CLI Procedure)There are two ways to connect and configure a J-EX Series switch: one method is throughthe console using the CLI and the other is using the J-Web interface. This topic describesthe CLI procedure.NOTE: To run the ezsetup script, the switch must have the factory defaultconfiguration as the active configuration. If you have configured anything onthe switch and want to run ezsetup, revert to the factory default configuration.See Reverting to the Default Factory Configuration for the J-EX Series Switch.Before you begin connecting and configuring a J-EX Series switch through the consoleusing the CLI:• Set the following parameter values in the console server or PC:• Baud Rate—9600• Flow Control—None• Data—8• Parity—None144Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
