Varning! Läs installationsanvisningarna innan du kopplar systemet till dessströmförsörjningsenhet.RelatedDocumentationGeneral Safety Guidelines and Warnings for J-EX Series Switches on page 201•• Laser and LED Safety Guidelines and Warnings for J-EX Series Switches on page 207• Grounded Equipment Warning for J-EX Series Switches on page 219• Connecting AC Power to a J-EX8200 Switch on page 131Chassis Lifting Guidelines for J-EX8200 SwitchesThe weight of a fully loaded J-EX8216 switch is approximately 486 lb (220 kg). Observethe following guidelines for lifting and moving the switch:WARNING: Because of the J-EX8216 switch’s size and weight, we require theuse of a mechanical lift to install the J-EX8216 switch in a rack or cabinet orto move the switch from one location to another.• Before moving the switch to a site, ensure that the site meets the power, environmental,and clearance requirements specified in the “Site Preparation Checklist for a J-EX8200Switch” on page 63.• Before lifting or moving the switch, disconnect all external cables and wires.• Do not grasp the switch by the blue panel at the top front of the chassis. Doing so cancause the panel to detach from the switch.RelatedDocumentationGeneral Safety Guidelines and Warnings for J-EX Series Switches on page 201•• Installation Instructions Warning for J-EX Series Switches on page 213• Mounting a J-EX8216 Switch on a Rack or Cabinet on page 108Ramp Warning for J-EX Series SwitchesWARNING: When installing the switch, do not use a ramp inclined at morethan 10 degrees.Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10graden.Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10degrés.214Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
