AC Power Cord Specifications for a J-EX8200 SwitchEach AC power supply has a single AC appliance inlet located on the power supply thatrequires a dedicated AC power feed. Sites can distribute power through a main conduitthat leads to frame-mounted power distribution panels, one of which can be located atthe top of the rack that houses the switch.NOTE: A jumper cable for each power supply was shipped with your switch.If your site uses a power distribution unit (PDU) to distribute power to therack that houses the switch, you do not have to purchase AC power cords.If your site does not use a PDU, you need an AC power cord for your geographical locationto connect each power supply on the switch to the power distribution panel. DetachableAC power cords for the switch are separately orderable as a field-replaceable unit (FRU)item.Each detachable AC power cord is 2.5 meters (approximately 8 feet) long. The appliancecoupler at the female end of the cord inserts into the AC appliance inlet on the faceplateof the AC power supply. The coupler type is C19 as described by the InternationalElectrotechnical Commission (IEC) standard 60320. The plug at the male end of thepower cord fits into the power source outlet that is standard for your geographical location.NOTE: In North America, AC power cords must not exceed 4.5 meters(approximately 15 feet) in length, to comply with National Electrical Code(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian ElectricalCode (CEC) Section 4-010(3). The cords shipped with the switch are incompliance.Table 39 on page 83 lists the AC power cord specifications for a J-EX8200 switch for thecountries and regions listed in the table.Table 39: AC Power Cord Specifications for a J-EX8200 SwitchPlug StandardsElectrical SpecificationsCountry/RegionRA/3/20, IRAM 2073250 VAC, 16 A, 50 HzArgentinaAS/NZS 3112250 VAC, 15 A, 50 HzAustraliaBR/3/20, NBR 14136:2002250 VAC, 16 A, 60 HzBrazilGB 1002250 VAC, 16 A, 50 HzChinaCEE (7) VII250 VAC, 16 A, 50 HzEurope (except Italy, Switzerland, andUnited Kingdom)ZA/3, SABS 164/1:1992250 VAC, 16 A, 50 Hz or 60 HzIndia83Chapter 7: Planning Power Requirements
