The virtual disk is undergoing a background initialization process. Would youlike to stop the operation and proceed with the initialization/consistency check> instead?Click Yes to stop the BGI and start the requested operation or No to allow the BGI to continue.Performing A Manual Rebuild Of An Individual Physical DiskCAUTION: If a physical disk is a member of a disk group that contains multiple virtual disks andone of the virtual disks is deleted when a rebuild operation is in progress, the rebuild operationstops. You can then resume the rebuild operation manually using a storage managementapplication. To avoid interruption, ensure that none of the virtual disks are deleted until therebuild is complete.Follow the procedures below to rebuild one failed physical disk manually:1. Press to access the PD Mgmt screen.A list of physical disks is displayed. The status of each disk is displayed under the heading State.2. Press the down-arrow key to highlight a physical disk that is in failed state.3. Press to display a menu of available actions.The Rebuild option is highlighted at the top of the menu.4. Press the right-arrow key to display the rebuild options and select Start.5. After you start the rebuild, press to display the previous menu.NOTE: You can also use the VD Mgmt screen to perform a manual rebuild. Use the arrow keyto highlight a physical disk, and press . In the menu that is displayed, select the Rebuildoption.Controller ManagementEnabling Boot SupportNOTE: See your system documentation to ensure the proper boot order is selected in the systemBIOS.In a multiple controller environment, you can enable BIOS on multiple controllers. However, if you wantto boot from a specific controller, enable the BIOS on that controller and disable it on the othercontrollers. The system can then boot from the BIOS-enabled controller. Perform the following steps toenable the controller BIOS:1. Press to access Ctrl Mgmt menu screen.2. Press to move the cursor to Enable Controller BIOS in the Settings box.3. Press the spacebar to select Enable Controller BIOS.An X is displayed beside Enable Controller BIOS.4. Press to move the cursor to the Apply button, and then press to apply the selection.The controller BIOS is enabled.To disable the controller BIOS, use the spacebar to de-select the Enable Controller BIOS control,and then select Apply and press .60
