Configuration OptionsThere are four main configuration option menus available in the UEFI RAID Configuration Utility. Thesemenus are outlined below.• Controller Management—Performs controller properties, foreign configurations, and battery, andother high-level controller functions.• Virtual Disk Management—Creates or deletes virtual disks, manages virtual disk properties, andperforms operations such as background initialization, consistency check, locate and reconfiguration.• Physical Disk Management—Displays physical disk properties and performs operations such as assignor unassign hot spares, locate, force online/offline, and rebuild after a physical disk failure.• Enclosure Management—Displays attached enclosures, enclosure firmware revision and physicaldisks attached to the enclosures.Controller Management MenuThe Controller Management menu can be used to perform the following controller-level functions. Eachof these functions is its own selectable menu option.• View Controller Information—Displays information about the controller.• Change Controller Properties—Updates controller properties and/or restores factory defaults for thecontroller.NOTE: For PowerEdge R920 system using PERC H730P, the option will read Change link Speedto Gen 3.– Boot Error Handling: Handles the errors found at boot.* Stop on errors: Interrupt the boot on all errors. Requires the user to either continue boot orenter the BIOS Configuration Utility to resolve errors.* Pause on errors: Interrupt the boot on serious errors. Requires the user to either continue bootor enter the BIOS Configuration Utility to resolve errors.* Ignore errors: The controller will take the default action for each error and will only halt bootwhen continuing is impossible.* Safe mode on errors: The system will continue booting as long as the boot volume is not onthis controller. Drives connected to the controller will be reported as unconfigured good drivesto the RAID management utilities upon a successful boot. No configuration changes will beallowed, except to clear the controller configuration if desired. Rebooting the system will exitsafe mode, and drives will appear as foreign on the next boot; if problems remain the systemwill enter safe mode again. If the boot volume is on this controller, boot will halt.• Battery Management— Displays battery status and capacity information.• Clear Configuration — Deletes all existing configurations on the controller.• Manage Foreign Configuration—Displays import and/or clears foreign configurations.• Save Controller Events—Saves a copy of the controller events file in the desired directory.• Clear Controller Events—Deletes all existing entries in the controller events file.• Save Debug Log—Saves a copy of the firmware’s terminal log entries for the controller.• Enable Security — Enables security on the controller via the desired security mode.• Disable Security—Disables security on the controller.• Change Security Key—Changes the security key or switches between security modes on thecontroller.• Convert To RAID Capable—Allows conversion of physical disks from Non-RAID to RAID Capable.• Convert To Non-RAID—Allows conversion of physical disks from RAID Capable to Non-RAID.63