Memory Or Battery Problem Error MessageError Message: Memory/Battery problems were detected. The adapter hasrecovered, but cached data was lost. Press any key to continueProbableCause:The message occurs under the following conditions:• The adapter detects data in the controller cache that has not yet been writtento the disk subsystem.• The controller detects an Error-Correcting Code (ECC) error while performingits cache checking routine during initialization.• The controller discards the cache rather than sending it to the disk subsystembecause the data integrity cannot be guaranteed.• The battery may be under charged.CorrectiveAction:Allow the battery to charge fully to resolve this problem. If the problem persists, thebattery or controller memory may be faulty. Contact Dell Technical Support.Firmware Fault State Error MessageError Message: Firmware is in Fault State.CorrectiveAction:Contact Dell Technical Support.Foreign Configuration Found Error MessageError Message: Foreign configuration(s) found on adapter. Press any key tocontinue, or ’C’ to load the configuration utility or ’F’ toimport foreign configuration(s) and continue.ProbableCause:When a controller firmware detects a physical disk with existing foreign metadata,it flags the physical disk as foreign and generates an alert indicating that a foreigndisk was detected.CorrectiveAction:Press at this prompt to import the configuration (if all member disks of thevirtual disk are present) without loading the BIOS Configuration Utility (). Or press to enter the BIOS Configuration Utility ( ) and eitherimport or clear the foreign configuration.Foreign Configuration Not Found In Error MessageError Message: The foreign configuration message is present during POST but noforeign configurations are present in the foreign view page in . All virtual disks are in an optimal state.CorrectiveAction:Ensure all your PDs are present and all VDs are in optimal state. Clear the foreignconfiguration using or Dell OpenManage Server Administrator StorageManagement.CAUTION: The physical disk goes to Ready state when you clear the foreignconfiguration.75