•name>—specifiesthe device name such as iDRAC, BIOS, NIC, LifecycleController, FC,system, or Storage.•—specifiesthe group name supported by the corresponding device.•—specifiesthe object for the entered group.Output•Thehelpcommand displays a complete list of subcommands.•Theracadmhelpcommand displays information for thespecifiedsubcommand only.•Theracadm help—g command displays information for thespecifiedgroup.•Theracadm help—o command displays information for thespecifiedobject.•Theracadmhelpname> command displays information for thespecifiedgroup.•Theracadmhelpname> command displays information for thespecifiedobject.•Theracadmhelp command displays information for thespecifiedobject.arpDescriptionDisplays the contents of the Address Resolution Protocol (ARP) table. ARP table entries cannot be added ordeleted.To use this subcommand, you must have Execute Diagnostic Commands.SynopsisracadmarpInputN/AExampleracadmarpOutputAddressHW TypeHW AddressMaskDevice192.168.1.1Ether00:0d:65:f3:7c:bfCeth0chassisactionDescriptionExecutes a power action on the chassis, KVM or a switch.To use this subcommand, you must have the Chassis Control Administrator privilege.Synopsisracadmchassisaction[-m ]Input•-m— Module on which you want to carry out the action. Values are:•—chassis— is the default value if-mis notspecified.—switch-where n=1–6—kvm•— Action that you want to execute on thespecifiedmodule. Values are:•—powerdown— (Chassis only) Powers down the chassis.—powerup— (Chassis only) Powers up the chassis.—powercycle— Power cycles the module.16
