Dell PowerEdge M1000e Reference Manual

Also see for PowerEdge M1000e: Manual Command reference guide Owner's manual Update Getting started guide

Contents

Dell PowerEdge M1000e Reference Manual Manual pdf 59 page image

tcp 0 0 127.0.0.1:199 127.0.0.1:52175 ESTABLISHEDtcp 0 0 192.168.0.32 192.168.0.31 ESTABLISHEDtcp 0 0 127.0.0.1:52174 127.0.0.1:199 ESTABLISHEDtcp 0 0 127.0.0.1:52887 127.0.0.1:8195 ESTABLISHEDpingDescription Verifies if the destination IP address is reachable from CMC with the current routing-table contents. Adestination IP address is required. Based on the current routing-table contents, an ICMP echo packet is sent tothe destination IP address.To run this subcommand, you must have the Administrator privilege.Synopsis racadm ping Input — The IP address of the remote endpoint to ping.Output PING 192.168.0 (192.168.0): 56 data bytes64 bytes from 192.168.0: seq=0ttl=64 time=4.121 ms192.168.0 ping statistics1 packets transmitted, 1 packets received, 0 percent packet lossround-tripmin/avg/max = 4.121/4.121/4.121 msping6Description Verifies if the destination IPv6 address is reachable from CMC or with the current routing-table contents. Adestination IPv6 address is required. Based on the current routing-table contents, an ICMP echo packet issent to the destination IPv6 address.To run this subcommand, you must have the Administrator privilege.Synopsis racadm ping6 Input — the IPv6 address of the remote endpoint to ping.Example Pinging 2011:de11:bdc:194::31 from 2011:de11:bdc:194::101 with 32 bytes ofdata:Reply from 2011:de11:bdc:194::31: time<1msReply from 2011:de11:bdc:194::31: time<1msReply from 2011:de11:bdc:194::31: time<1msReply from 2011:de11:bdc:194::31: time<1msPing statistics for 2011:de11:bdc:194::31:Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),Approximate round trip times in milli-seconds:Minimum = 0ms, Maximum = 0ms, Average = 0msracdumpDescription Provides a single command to get dump, status, and general CMC board information.This subcommand displays the comprehensive chassis status, configuration state information, and historicevent logs. Used for post deployment configuration verification and during debugging sessions.To run this subcommand, you must have the Administrator privilege.59