Figure 23. Removing a hot swappable hard drive or SSD1 release button 2 hard drive or SSD carrier3 hard drive or SSD carrier handleRelated linkSafety instructionsRemoving the optional front bezelInstalling the optional front bezelInstalling a hot-swap hard drivePrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simplerepairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damagedue to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that areshipped with your product.CAUTION: Use only hard drives that have been tested and approved for use with the hard drive backplane.CAUTION: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard drive carrier andattempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and makeit unusable.CAUTION: Combining SAS and SATA hard drives in the same RAID volume is not supported.CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentationsupplied with your operating system.CAUTION: When a replacement hot swappable hard drive is installed and the system is powered on, the hard drive automaticallybegins to rebuild. Make absolutely sure that the replacement hard drive is blank or contains data that you wish to have over-written. Any data on the replacement hard drive is immediately lost after the hard drive is installed.Steps1 If a hard drive blank is installed in the hard drive slot, remove it.2 Install a hard drive in the hard drive carrier.3 Press the release button on the front of the hard drive carrier and open the hard drive carrier handle.4 Insert the hard drive carrier into the hard drive slot until the carrier connects with the backplane.5 Close the hard drive carrier handle to lock the hard drive in place.82 Installing and removing system components
