Installing System Components 913 Locate the SD card connector on the internal SD module and, with thelabel side facing up, insert the contact-pin end of the card into the slot.See Figure 3-8.NOTE: The slot is keyed to ensure correct insertion of the card.4 Press the card into the card slot to lock it into place.5 Close the system. See "Closing the System."6 Reconnect the system to power and restart the system.Removing the Internal SD Flash CardCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Locate the SD card slot on the internal SD module and press inward onthe card to release it from the slot and remove the card.4 Close the system. See "Closing the System."5 Reconnect the system to power and restart the system.Internal USB Memory KeyAn optional USB memory key installed inside your system can be used as aboot device, security key, or mass storage device. The USB connector must beenabled by the Internal USB Port option in the Integrated Devices screen ofthe System Setup program. See "Using the System Setup Program and UEFIBoot Manager."To boot from the USB memory key, configure the USB memory key with aboot image and then specify the USB memory key in the boot sequence in theSystem Setup program.