94 Installing System Components8 Close the system. See "Closing the System."9 Reconnect the system and peripherals to their power sources, and turnthem on.Integrated Dell Remote Access Controller 6(iDRAC6) Enterprise Card (Optional)The optional iDRAC6 Enterprise card provides a set of advanced features formanaging the server remotely.Installing an iDRAC6 Enterprise CardCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Remove the plastic filler plug for the iDRAC6 Enterprise port from thesystem back panel. See "Back Panel Features and Indicators" for the portlocation.4 If installed, remove all expansion cards from expansion-card riser 1. See"Removing an Expansion Card."5 Install the iDRAC6 Enterprise card:a Angle the card so that the RJ-45 connector fits through the back-panelopening. See Figure 3-10.b Align the front edge of the card with the two front plastic retentionstandoffs next to the iDRAC6 connector on the system board. SeeFigure 6-2 for the location of the connector.c Press the card down until it is fully seated. See Figure 3-10.When the front of the card is fully seated, the plastic standoffs snapover the edge of the card.