Entering the system Service Tag by using System SetupIf Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.Steps1. Turn on the system.2. Press F2 to enter System Setup.3. Click Service Tag Settings.4. Enter the Service Tag.NOTE: You can enter the Service Tag only when the Service Tag field is empty. Ensure that you enter the correctService Tag. After the Service Tag is entered, it cannot be updated or changed.5. Click OK.6. Import your new or existing iDRAC Enterprise license.For more information, see the Integrated Dell Remote Access Controller User's Guide at www.dell.com/poweredgemanuals .Trusted Platform ModuleTrusted Platform Module (TPM) is a dedicated microprocessor designed to secure hardware by integrating cryptographic keys intodevices. A software can use a Trusted Platform Module to authenticate hardware devices. As each TPM chip has a unique and secretRSA key burned in as it is produced, it can perform the platform authentication.CAUTION: Do not attempt to remove the Trusted Platform Module (TPM) from the system board. After the TPM isinstalled, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM breaksthe cryptographic binding, and it cannot be re-installed or installed on another system board.NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dellcertified service technicians.Installing the Trusted Platform ModulePrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting andsimple repairs as authorized in your product documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and followthe safety instructions that are shipped with your product.NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dellcertified service technicians.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.Steps1. Locate the TPM connector on the system board.NOTE: To locate the TPM connector on the system board, see the System board connectors section.2. Align the edge connectors on the TPM with the slot on the TPM connector.3. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.4. Press the plastic rivet until the rivet snaps into place.Installing and removing system components 139
