Figure 49. Installing the internal USB memory keya. USB memory keyb. USB portNext steps1. Follow the procedure listed in the After working inside your system section.2. While booting, press F2 to enter System Setup and verify that the USB memory key is detected by the system.Expansion cardsAn expansion card in the system is an add-on card that can be inserted into an expansion slot on the system board or riser card to addenhanced functionality to the system through the expansion bus.Expansion card installation guidelinesYour system supports Generation 3 cards. The following table lists the supported expansion cards:Table 22. PCI Express Generation 3 expansion cards supportedPCIe Slot Processor Connection Height Length Link Width Slot Width1 Processor Full Height Half Length x4 x82 Processor Full Height Half Length x8 x163 Platform Controller Hub Full Height Half Length x1 x14 Platform Controller Hub Full Height Half Length x4 x8NOTE: All slots support Generation 3 PCIe expansion cards.NOTE: The expansion cards are not hot swappable.The following table provides a guide for installing expansion cards to ensure proper cooling and mechanical fit. Install the expansion card byfollowing the card priority and slot priority order as shown in the table.Table 23. Expansion card installation orderCard Priority Card Type Form factor Slot Priority Maximum Allowed1 PowerEdge RAID Controller (PERC)H730Full Height 2, 1, 4 1PERC H330 Full Height 2, 1, 4 1PERC H830 Full Height 2, 1, 4 22 10 G NICs Dual Port (Intel) Full Height 2, 1, 4 392 Installing and removing system components
