Setting Date and Time on CMC Using CMC Web InterfaceTo set the date and time on CMC:1. In the left pane, click Chassis Overview → Setup → Date/Time .2. To synchronize the date and time with a Network Time Protocol (NTP) server, on the Date/Time page, select EnableNTP and specify up to three NTP servers. To manually set the date and time, clear the Enable NTP option, and thenedit the Date and Time fields.3. Select the Time Zone from the drop-down menu, and then click Apply.Setting Date and Time on CMC Using RACADMTo set the date and time using the command line interface, see the config command and cfgRemoteHosts databaseproperty group sections in theChassis Management Controller for PowerEdge VRTX RACADM Command Line ReferenceGuide available at dell.com/support/manuals.Configuring LEDs to Identify Components on the ChassisYou can enable the LEDs of components (chassis, servers, physical disk drives, virtual disks, and I/O Modules) to blinkso that you can identify the component on the chassis.NOTE: To modify these settings, you must have the Chassis Configuration Administrator privilege.Configuring LED Blinking Using CMC Web InterfaceTo enable blinking for one, multiple, or all component LEDs:• In the left pane, go to any of the following pages:– Chassis Overview → Troubleshooting.– Chassis Overview → Troubleshooting.– Chassis Overview → Chassis Controller → Troubleshooting .– Chassis Overview → Server Overview → Troubleshooting .NOTE: Only servers can be selected on this page.– Chassis Overview → I/O Module Overview → Troubleshooting .– Storage → Troubleshooting .NOTE: Only physical disk drives and virtual disks can be selected on this page.To enable blinking of a component LED, select the Select/Deselect All option corresponding to the physical disk drive orvirtual disk, and then click Blink. To disable blinking of a component LED, clear the Select/Deselect All optioncorresponding to the LED, and then click Unblink.Configuring LED Blinking Using RACADMOpen a serial/Telnet/SSH text console to CMC, log in, and type:racadm setled -m <module> [-l <ledState>], where specifies the module whose LED youwant to configure. Configuration options:35
