Using the System Setup Program and UEFI Boot Manager 57Embedded System ManagementThe Lifecycle Controller is an embedded utility that enables systemsmanagement tasks from an embedded environment throughout the server’slifecycle.The controller can be started during the boot sequence and can functionindependently of the operating system.NOTE: Certain platform configurations may not support the full set of featuresprovided by the controller.The following features of the Lifecycle Controller are supported on systemswith Baseboard Management Controller (BMC):• Installing an operating system• Running diagnostics to validate the memory, I/O devices, processors,physical disks, and other peripheralsWhen an optional iDRAC6 Express card is installed, the controller providesthe following additional features:• Downloading and applying firmware updates• Configuring hardware and firmwareFor more information about setting up the controller, configuring hardwareand firmware, and deploying the operating system, see the Lifecycle ControllerUser Guide on the Dell Support website at support.dell.com/manuals.Baseboard Management Controller ConfigurationNOTE: If an iDRAC6 Express card is installed on the system, the BaseboardManagement Controller (BMC) utility is replaced by the iDRAC6 utility.The BMC enables configuring, monitoring, and recovery of systems remotely.BMC provides the following features:• Uses the system’s integrated NIC• Enables fault logging and SNMP alerting• Provides access to system event log and sensor status• Allows control of system functions including power on and off• Functions independently of the system’s power state or the system’soperating system