Installing System Components 97Installing the Storage Controller CardCAUTION: Many repairs may only be done by a certified service technician.You should only perform troubleshooting and simple repairs as authorized inyour product documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is notcovered by your warranty. Read and follow the safety instructions that camewith the product.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System" on page 64.3 If installed, remove the expansion card. See "Removing an ExpansionCard" on page 92.4 Route the cables in the cable path under the storage controller card slot onthe expansion card riser.5 With the storage controller card edge facing the riser, insert one side of thecard into the black card-edge guide.NOTE: For expansion-card riser 1, the installation sequence must beslot 3, 2, 1, and 4. The storage controller card must be installed in Slot 4 afterthe other expansion cards have been installed.6 Bend outward on the blue card-edge guide, lower the card onto the bluecard-edge guide, and release the guide. See Figure 3-15.7 Slide the storage controller’s card edge connector into the card slot on theriser until the card is fully seated.8 Connect the two SAS data cable connectors, CNTRL 0 and CNTRL 1, tothe storage controller card. See Figure 3-15.NOTE: Ensure to connect the cables according to the connector labels on thecable. The cable does not function properly if reversed.9 For a battery-cached RAID controller, connect the RAID battery cable tothe controller card.
